ADCP-90-516 • Rev B • April 2019
Page 11
© 2019, CommScope, Inc.
Use the following procedure to mount the panel on the rack:
1. Remove the front cover of the panel by opening the cover approximately two inches
(5 cm) then lifting the cover from the hinges.
2. Unlatch and open the bulkhead panel.
3. Remove the VCG from the left side of the panel and in its place install the VCG provided
with the kit.
4. Position the panel on the rack.
5. Align the VCG mounting holes to the corresponding holes in the rack and secure the panel
to the rack using #12-24 screws (provided).
6. Align the mounting holes in the right side of the panel with the corresponding holes in the
rack, and secure the panel to the rack using # 12-24 screws (provided).
3.1.5
23-Inch Centered Rack Mount With Extender Brackets
The FL2000 23-Inch Centered Rack Mount Kit (not provided) is used to center-mount the panel
on a 23-inch rack. Using a Flush Mount Kit the panel can be mounted flush, 1-, 2- or 4-inch
position.
shows the panel and kit components.
Figure 9. FL2000 23-Inch Centered Mounting (Top View)
Use the following procedure to mount the panel on the rack:
1. Remove the front cover of the panel by opening the cover approximately two inches
(5 cm) then lifting the cover from the hinges.
Note:
Removing the front cover and opening the bulkhead panel provides access to the
mounting holes at the right side of the panel (as viewed from the front).
5 IN.
RECESS
EXTENDER
BRACKET
5 IN.
RECESS
EQUIPMENT
RACK
EQUIPMENT
RACK
17262-A
EXTENDER
BRACKET
