MT Series DryLine
®
Dehydrator User Manual
19
If you experience difficulty with your dehydrator,
use the troubleshooting procedures described
on the next page. Perform the tests, inspections
and corrective actions corresponding to the
problem in the order listed. See System
configuration diagram Basic or System
configuration diagram Multi-Line for piping
connections and Door Schematic or Chassis
Schematic for wiring. Section 7 lists replaceable
parts.
CommScope Technical Service. If you cannot
correct the problem or if there are other
difficulties, contact the CommScope Technical
Service nearest you. Telephone numbers are
listed on Customer Support Section 9.
Note:
Run the dehydrator to dry it out prior to
connecting it to the system. Run it until the
high humidity alarm clears (if so equipped).
The drying process should take about 45
minutes, if the membrane dryer was not
saturated. If the membrane dryer was
saturated, drying may take up to 48 hours.
Caution:
High voltage exists inside the
unit. Disconnect the unit whenever
performing troubleshooting operations.
StockCheck.com
