Installation instruction CMAX-O-xxx antennas
Page 1
M0149ABC_Installation_CMAX-O-xxx-Antennas
Installation of CMAX-O-CPUSEWV53 /
CMAX-O-UW-I53 Antennas
Note: Please read the complete description before starting the installation. Make sure that
connectors are properly sealed against water if no cables are connected to them after
installation.
Installation without the Ceiling Mount kit:
Installation Steps
1) Cut a hole in the ceiling tile with the diameter shown above.
2) Remove the retaining nut from the back of the antenna (labeled tight part for connector in the
diagram above).
3) Feed the pigtail of the antenna through the hole in the ceiling tile.
4) Re-install the retaining nut so that it is snug against the ceiling tile.
Note
1) Cable min. bending radius: 40mm
2) For massive/hard ceilings, please use Hard Ceiling
Mounting Kit 7705125 which serves to guide the
jumper to the side. For this kit, a separate instruction
(M0149AWx) is available:
