Figure 1
MRJ21 48–port straight patch panels are designed to
be mounted onto a standard 483–mm [19–in.]
Electronic Industries Alliance (EIA) rack or equipment
cabinet as shown in Figure 1. AMPTRAC patch
panels
are designed for use with the
AMP NETCONNECT®
AMPTRAC system. Read these
instructions thoroughly before starting installation.
AMPTRAC Retrofit Kit 1479951–1 can be installed
onto
the standard patch panel to enable the patch
panel to
be connected to the
AMP NETCONNECT®
AMPTRAC
system. Back Cable Manager Kits
1933352–[ ] must be
used to support the cable.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
Each 10/100BASE–T patch panel contains four
MRJ21 receptacles (one per 2
6 RJ45 connector
assembly), and each 10/100/1000BASE–T patch
panel contains eight MR21 receptacles (two per 2
6
RJ45 connector assembly). The ports are identified
by numbers printed on the front and on the back of
the patch panel. Four 12–24 screws are included to
mount the patch panel to the rack. In addition,
AMPTRAC patch panels have a sensor pc board
subassembly and two HDP–22 connectors to enable
the patch panel to connect to the
AMP NETCONNECT®
AMPTRAC system.
AMP NETCONNECT®
9-JAN-17
Rev E
© 201
7
CommScope, Inc.
All Rights Reserved
This product is covered by one or more U.S.
patents or their foreign equivalents. For patents, see
www.commscope.com/ProductPatent/ProductPatent.aspx
To obtain information on CommScope
®
products, visit our website at
http://www.commscope.com/SupportCenter/TechnicalSupport.aspx
