848380986
Instruction Sheet
www.commscope.com
Page 8 of 11
Step 2 – Install Faceplate Base and Route New Fiber Cables
1. Strip 3 feet (1 meter) of jacket from the fiber cable.
2. Attach fiber cable to base using a cable tie at one of the cable tie down points around the inside of the slack
drum. The jacket should extend 1/4-to 1/2-inch (6 to 13mm) past the cable tie.
3. Terminate fibers with the appropriate connectors and plug into the adapter plate couplers.
4. Loop the slack fiber around the take-up spool and snap the coupler plate into the desired position (inboard or
outboard) on the base.
5. Feed faceplate through back of faceplate base as shown in figure above.
