Use and Care Guide
METAL
110
0 LUMEN LED SPIKE LIGHT
Safety Information
WARNING:
Risk of Fire, Electric Shock,
or Injury to Persons. Turn the power off at
the circuit breaker or fuse and install in
accordance with local electrical codes.
WARNING:
material.
Installation
1
PLACING THE SPIKE LIGHT
□
Hold the light by the base of the
spike and gently push the spike
into the ground. The
(
B
)
flat base
of the spike should be
at ground
level when finished and the spike
should be vertical. In rocky or
hard packed dirt, use a small
shove
l to dig up rocks and loosen
the soil. Place the spike(
B
) in the
ground and pack the dirt in and
around it to secure it.
2
3
AIMMING THE SPIKE LIGHT
□
Ensure the power is off.
Loosen the adjustment screw
(
A
)
on the side of the light,tlit
the fixture up or down.
Tighten the adjustment screw
(
A
). Restore power. Repeat
this step until the desired
angle is achieved
A
Pre-Installation
NO TOOL REQUIRED.
Please clear the area for installation (above and 10 inches under
ground) from hard objects.
For best result, moist the soil from of the surround area for easier
installation
5
-Year Limited Warranty
WHAT IS COVERED
This product is guaranteed to be free of factory defective parts and workmanship for a period of 5 years
from date of purchase. Purchase receipt is required for all warranty claims.
WHAT IS NOT COVERED
This guarantee does not include repair service, adjustment and calibration due to misuse, abuse or
negligence or unauthorized service or modification of the product or of any finished component will void
this warranty in its entirety. This warranty does not include reimbursement for inconvenience,
installation, setup time, loss of use, unauthorized service, to return shipping charges. No service parts
are available for this product.
Contact the Customer Service Team at 1-877-527-0313 or visit www.homedepot.com
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Item #
10024218
30
Model#
SPK
M
-
14
W0
3
B
A
Please read and understand these instructions before attempting to
install or use this light fixture.
1.
This LED fixture is suitable for outdoor use and wet locations.
2.
Do not disassemble this LED fixture. There are no user-serviceable
parts inside. The LED bulb is not replaceable.
3.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1)This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
4
□
Plug the power
cord
(C)
into
a
grounded
and
GFCl-protected
three
-prong
extension cord or
the
wall
o
utlet
C
CONNECTING TO POWER SOURCE
C
CONNECTING THE LIGHT WITH THE SPIKE
□
Attached the light to the spike by
unscrew the adjustment screw(A),
match the hole at the top of the
spike, reinstall the screws (A),
and tighten the screw.
A
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
