2
Table of Contents
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Safety Information
IMPORTANT SAFETY INSTRUCTIONS. SAVE
THESE INSTRUCTIONS.
Most electrical accidents are caused by carelessness or ignorance.
Review these basic electrical guidelines before you begin this
installation.
□
Use tools with insulated handles and ladders made of wood or
fiberglass.
□
Keep dry-chemical fire extinguishers in the kitchen, basement,
and workshop.
□
Never disable grounding devices. Ensure all appliances that
require grounding are properly grounded, and that the electrical
system itself is properly grounded.
□
Meet or exceed all electrical code requirements that cover the
work you are doing.
□
Always work with enough light to see what you are doing. It is
easy to make a mistake when you work in dim light.
□
When in doubt about the safety of any electrical repair or test,
call in a professional.
□
This fixture is IC rated for direct contact with insulation.
□
This fixture is intended for indoor or wet location use.
□
Do not modify this fixture. If any modifications are made, it may
render the product unsafe and void the warranty.
WARNING:
Before touching any wire, use a voltage tester
to ensure it is not live.
WARNING:
When you check for voltage in a receptacle,
check both outlets as each may be controlled by a separate
wiring circuit.
WARNING:
Before working on a circuit, go to the main
service panel and remove the fuse or trip the breaker that
controls that circuit. Tape a sign to the panel warning others
to leave the circuit alone while you work.
WARNING:
When replacing fuses, turn off the main power
first. Make sure your hands and feet are dry, and place one
hand behind your back to prevent electricity from making a
complete circuit through your chest. Touch a plug fuse only
by its insulated rim. Remove cartridge fuses with a fuse
impeller.
WARNING:
CONSULT A QUALIFIED ELECTRICIAN TO
ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR.
WARNING:
Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
□
Reorient or relocate the receiving antenna.
□
Increase the separation between the equipment
and receiver.
□
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
□
Consult the dealer or an experienced radio/TV
technician for help.
FCC Responsible Party
Globe Electric
1-888-353-1388
15301 Shoemaker Ave
Norwalk, CA 90650
www.globe-electric.com
