2
Table of Contents
Safety Information .....................................................2
Warranty.....................................................................2
Pre-Installation ..........................................................3
Preparing for Installation ..........................................5
Installation .................................................................5
Operation....................................................................8
Care and Cleaning .....................................................8
Troubleshooting .........................................................9
Safety Information
IMPORTANT
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE
WITH THE APPLICABLE NATIONAL ELECTRICAL CODE AND
LOCAL BUILDING CODES BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
PRECAUTIONS
□
Please read and understand this entire manual
before attempting to assemble, install, or operate
this light fixture.
□
This light fixture requires a 120-Volt AC power
source.
□
Some codes require installation by a qualified
electrician.
□
This light fixture must be properly grounded.
□
Make sure connections are secure using wire nuts,
crimp-on lugs or other UL approved connecting
devices.
□
This light fixture should be installed outdoors to a
wall.
□
This product may contain chemicals known to be
hazardous. Thoroughly wash hands after installing,
handling, cleaning or otherwise touching the
product.
WARNING:
Before installation or servicing of the fixture,
turn the power OFF at the circuit breaker or fuse. Place
tape over the circuit breaker switch and verify power is
OFF at the light fixture.
WARNING:
Risk of fire. Keep the light fixtures at least
3 in. (76 mm) from combustible materials.
CAUTION:
Burn hazard. Allow the light fixture to cool
before touching.
NOTICE:
Do not connect this fixture to a dimmer switch.
NOTICE:
FCC Regulations state that any unauthorized changes
or modifications to this equipment not expressly approved by the
manufacturer could void the user’s authorization to operate this
equipment.
IMPORTANT:
The device is tested and found to comply
with Part 15 of the FCC Rules. Operation is subject to
two conditions: (1) This device may not cause harmful
interference and, (2) this device must accept any
interference received, including any interference that may
cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part
15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
The equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications. Operation
of the equipment in a residential area is likely to cause
harmful interference in which case the user will be
required to correct the interference at his own expense.
Warranty
This is a limited warranty offered by the manufacturer for a period of five years from the date of purchase to its
customers. The manufacturer warrants to customers that the products will be free from defects in material and
workmanship. The obligation of the manufacturer under this warranty is limited to the provision of replacement
of products and is extended to the original purchaser of the product on presenting valid purchase receipt or other
proof of date of original purchase acceptable to the manufacturer. The receipt is required for rendering the warranty
performance. Any warranty claims without original proof of purchase would not be accepted.
It should be noted that the warranty does not apply to the manufacturer products that have been altered or repaired
by unauthorized personnel, have been subjected to neglect, abuse, misuse or accident or damages caused during
shipping. Any other products not manufactured by the manufacturer which have been supplied, installed and/or
used in conjunction with the manufacturer products are not covered under this warranty. Any damages caused by
replacements bulbs, LEDs or corrosion or discoloration of brass components are also not covered by this warranty.
