6
Installation (continued)
4
Installing the exit/emergency
light to the wall
□
Punch out the appropriate mounting pattern and
wire hole on the backplate (C) to fit the junction
box. Feed the wires through the wire hole.
□
Connect the wiring. Refer to “6 Connecting the
wiring”.
□
Secure the frame (B) to the junction box using
the junction box screws (not included) (1).
C
B
1
5
Installing the exit/emergency
light with conduit
WARNING:
This product must be installed in accordance
with the applicable building codes, electric codes and
ordinances. Be sure to comply with your local and state
regulations. It is recommended that this product be
installed be by a licensed electrician or by qualified service
personnel.
□
Route the conduit power supply wires through
the conduit knockout (1) (1a) or through the rear
of the backplate (C) (1b) and make the conduit
connection.
□
Connect the wiring. Refer to “6 Connecting the
wiring”.
□
Using the backplate (C) as a template, mark and
drill two installation holes on the wall at the
desired installation location.
□
Insert wall anchors (CC) into the holes.
□
Attach the backplate (C) to the wall by inserting
screws (DD) through the backplate (C) and into
the wall anchors (DD).
C
B
CC
C
B
DD
1
CC
DD
1a
1b
