commend.com
RJ45
Reset
USB 2.0
I/Os
IN3
GND
OU
T2 NC
OU
T2 COM
OU
T2 NO
IN1
IN2
OU
T1 NC
OU
T1 COM
OU
T1 NO
IN
|
3
Security and Communication
The design and/or specifications of products may be subject to change for improvement without prior notice. Errors excepted.
OD10 TD CM
DATA SHEET V1.3/0522
Connection
Cut out the wall (see “Dimensions”).
Insert the mounting box onto the wall with the arrow pointing upwards.
Press the four claw clamps on the sides of the mounting box outwards
and tighten them using the corresponding screws (TX 10).
Pierce one of the provided cable glands depending on cable supply
(from top, bottom or rear). Guide the required cables through this entry
( Ethernet, I/O and USB cable, if needed), run the cables along the corners
of the mounting box and adjust them to the desired length.
Follow the enclosed instructions on how to mount the optional Ethernet
socket RJ45-MONT to the cable and connect it to the station. Insert the
Ethernet socket with its gib head on the right at the intended position
and clip it on the left. OD10 FB is specifically designed to accomodate
RJ45-MONT.
Fix the cables on the provided strain-relief using the cable ties included in
extent of supply of the OD10 TD CM.
Attach the blind cover included in extent of supply to the bottom side of
the Intercom station using a screwdriver (TX 10, not included in extent of
supply).
Connect the cables to the Intercom station and the Ethernet socket
( Ethernet, I/O and USB cable, if needed).
Place the Intercom station on the mounting box so that the Intercom
station attaches to every hook. Press the Intercom station onto the
mounting box and push it downwards to lock it.
Turn the two lateral locking screws clockwise out as far as it will go using
the TX 08 screwdriver (included in extent of supply of the OD10 TD CM).
Check whether the Intercom station is fixed on the mounting box.
Wall mounting with OD10 FB
NOTE: Wall mounting
–
For mounting on brick walls, additionally the flush mount box OD10 FBS
is required (not included in extent of supply). In this case, plaster the
flush mount box OD10 FBS into the wall and then continue with
.
– To ensure that the tamper detection functions correctly, the magnet in
the lower part of the mounting box must not be covered, damaged or
electromagnetically influenced.
– Due to the IP protection class requirements, considerable force may
need to be applied when pressing the Intercom station onto the mount-
ing box.
