7
6
6
Axis electronic module: camera angle/web interface login
2
2
5
3
1
NET
STAT
PWR
4
Axis electronic module: control button
Disposal and recycling
Equipment with this symbol shall not be disposed of together with household or
commercial waste.
The directive 2012/19/EU on waste electrical and electronical equipment (WEEE) is
applicable in the European Union member states.
Manufacturer’s reference
This device complies with the European directives listed below by fulfilling corresponding
standards:
• Electromagnetic compatibility (directive 2014/30/EU)
• The restriction of the use of certain hazardous substances in electrical and electronic
equipment (directive 2011/65/EU)
For technical specifications, see the respective data sheet.
Keep this description in safe custody.
Observe the precautions for handling of electrostatic sensitive devices.
Handling
Use the original packaging when transporting the device to prevent damage.
Adjusting the camera
Note:
First connection
Login for Axis web interface
Follow the steps below to adjust the angle of the camera:
1. Loosen the screw
5
(Torx T8).
2. Open up the Axis electronic module
6
.
3. Loosen the locking screw
7
(Torx T25) on the rear of the camera.
4. Adjust the camera in the desired angle (max. 25° in every direction).
5. Tighten the locking screw
7
.
6. Move the Axis electronic module
6
back into its original position.
7. Tighten the screw
5
.
For further information on installation and settings, see Axis manual “
P3904-R
”.
The IP address is assigned directly via a DHCP server. If the network does not have a DHCP server, the
default address “192.168.0.90/24” is used.
The web interface can be accessed via a web browser using the URL “http://
<IP address>
“. Additionally,
the URL “http://
<user name
>:<
password
>@
<IP address>/
axis-cgi/mjpg/video.cgi“ can be entered in a
web browser to directly access the MJPEG stream.
User name: root
Password: root
Attention:
After a reset, the password has to be configured manually.
Control button
Follow the steps below to operate the control button:
1. Loosen the screw
1
(Torx T8).
2. Turn the safety lever
2
outwards.
3. Push the control button
3
.
4. Turn the safety lever
2
back into its original position and tighten the screw
1
.
Follow the steps below to reset the camera to the factory default settings using the control button:
1. Disconnect the power supply from the camera.
2. Press and hold the control button
3
and reconnect the power supply.
3. Keep the control button pressed until the LED indicator
4
flashes amber.
4. Release the control button. If the status LED
4
turns green, the process is complete.
Attention:
After a reset, the camera must be reconfigured, otherwise the camera image would appear 180° up-
side down.
Type: D-BZ-WS2X1VICA, Version: 2.1/0418
Commend International GmbH, Saalachstraße 51, A-5020 Salzburg – www.commend.com
Cables must never be placed in the space between the black protective plate of the Axis camera
module and the wall mount box. Doing so may cause damage to the Axis camera or compromise the
tightness of the Intercom station’s housing.
Warning:
