IP Stations WS 201VICA/WS 211VICA
Connection diagram
160 (6.3)
140 (5.5)
275 (1
0.84)
255 (1
0.05)
4x
Ø
7
(0.28)
appro
x. 1
.65
m
(5.4 ft)
Finished floor
Dimensions and recommended mounting height
Measurements in mm (in), not scale! Front panel thickness: 3 mm (0.12 in)
OUT 2
OUT 2
OUT 2
OUT 2
OUT 1
OUT 1
EP+
EP–
EM+
EM–
MUTE
GND
LINE–
LINE+
IN 1
IN 2
IN 3
GND
external
loudspeaker
module
IP downlink
(Axis camera
+ PoE)
expansion bus
IP uplink
+ PoE
LED brightness
+
–
handset:
microphone
loudspeaker
slot for inserting
button label
The camera illuminator and heating control are connected to the main board of the subscriber
via the expansion bus. In CCT 800, the device is shown with an additional EB2E2A device.
• Use OUT 1 on the EB2E2A to switch the camera illuminator on and off.
It is also possible to use OUT 1 as attendant contact, e.g. to switch on the camera illuminator
at call setup.
To dim the camera illuminator, use the potentiometer
2
on the camera board.
• Use OUT 2 on the EB2E2A to switch the camera heating on and off.
Camera illumination and heating control
1
1
2
Extent of supply
• Station
• Mounting screws (4 x Torx TR 25 security countersunk screws, M5 x 10)
• Snap-on ferrite (to be attached to IP uplink Ethernet cable)
• Short reference
Cleaning instructions
Safety instructions
The device may only be cleaned with cleaning agents for stainless steel. Do not use cleaning agents
containing chlorine or isopropanol.
• This device shall be installed or replaced by trained and qualified personnel only.
• Do not install the device on unstable walls or on surfaces which cannot support the device’s weight.
• Only use recommended tools when installing the device.
• Only accessories that comply with the device’s technical specifications shall be used.
• All connected circuits shall fulfil the requirements for Safety Extra Low Voltage (SELV) and Limited
Power Source (LPS) according to IEC/EN 60950-1.
• Use shielded Ethernet cables only.
• Before using the device, ensure all cables are correctly connected and not damaged.
• Disconnect the power supply (PoE or DC) for any maintenance of the device.
• Allow the device to cool down completely before touching parts inside.
• Do not make any unauthorised modifications to the device.
