Step 10:
Plug the actuator extension cables into the
actuators then the other end plug into the control box.
Plug the LED controller into the remaining socket.
Then plug the IEC power cable into the other end of
the control box. Run the power board lead through the
hole in the back of part 973, pull out the lead retaining
brackets and bend into a 45° shape as shown. Plug
the IEC power lead into the power board.
Step 9:
VESA Rails,
Using 8x 8x12mm bolts
and nylock nuts secure
the top part 974 into
position as shown..
Then loosely secure
the bottom part 974 into
position it should be
able to freely move
within the slots this part
will be secured after the
panel is in place.
