TP–nKP
Cautions for installation
Troubleshooting
Wiring Diagram
1. Total connected cable length shouldn’t be over 1km between first & last product (0.65m/m)
2. Be sure not to change the wiring sequence.
1. A voice through the phones feels quite low or they are not working at all.
▶
Test total three interphones with short wires than normal or connected 1 more power source.
2. It doesn’t make a call to the targeted interphone
▶
Check the connection wire “L” on “Terminal BOX”.
3. A certain unit does not work properly.
▶
Change each unit to check which one makes malfunction.
Installation manual
1. Installation tools & parts : Nipper, Screw driver, UTP cable(Cat 6.E)
2. Products: TP-4/6/10KP , RF-1A
3. Wiring & setting method
3-1. Put TP-4/6/10KP on the place to install and open the cover of
“Terminal BOX”.
3-2. Unscrew slightly 1~4,6,10th,L1,+,-P,-1 with screw driver
▶
From first interphone to the last one all connectors should be connected in
parallel except “L”,”-1”
▶
First interphone : Move the wire on “1” terminal to “L” terminal.
Make “P” and “1” terminals in short.
▶
Second interphone : Move the wire on “2” terminal to “L” terminal.
Make “P” and “2” terminals in short.
▶
tenth interphone : Move the wire on “10” terminal to “L” terminal.
Make “P” and “10” terminals in short.
3-3. After complete wiring, screw them all tightly.
3-4. Connect “RF-1A” to se , - terminals
* For additional speakers, refer to user manual
STA1
STA2
STA3
STA4
STA5
STA10
Own No. Terminal
Common Talk Terminal
Paging Terminal
External Speaker
