5. Attach the Belt Clip, as shown below if required:
Note:
The handset should be used with an original power adapter only. The use of a
third-party power adapter may cause the damage to the handset. The charging status of
the handset is indicated in the top right-hand corner of the LCD screen.
3. Connect the charger cradle and charge the handset, as shown below:
Level 10, 452 Flinders St Melbourne VIC 3000
ABN 85 136 950 082
After the IP phone is connected to the network and supplied with power, it automatically
begins with the initialisation process.
Please allow up to 10-15 minutes for the phone to connect to Commander’s servers to
collect their configuration and any required updates to both the base station and handset/s.
The phone may reboot two or three times during this process or after factory default setting
is made. Do
NOT
interrupt this process. The display may indicate the current status of the
operation with ‘
initialising
’ and ‘
configuration updating
’. After startup, the phone is ready for use.
If you require assistance, please call the Commander
Phone team on 1300 638 208, or email us at [email protected].
