Guide d’installation
P. 7
Ignition Re-lock
On remote starters of this series, when ignition-controlled door locks
are enabled and the ignition
key is in the
IGNITION ON (RUN)
position, should any door be unlocked and opened, all doors will be
relocked next time the brake pedal is pressed.
Secure Lock
Before it can remote-start your vehicle, the remote starter must first disarm the factory security
system. The secure lock feature may be required on certain vehicle models with factory security
systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
secure lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, secure lock will rearm your factory security system.
Turbo Mode
When left in turbo mode, the remote starter will keep the engine running for 60 seconds before
shutting it down. This is to allow a turbocharger to idle down after the user leaves the vehicle. See
Turbo Mode
section on page 3.
Remote Trunk Release
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
TRUNK
button for 3 seconds on the remote transmitter or by pressing the
TRUNK
button
TWICE
within 3 seconds.
Engine Run Time
If you have a gas engine, your remote starter can be programmed to run the engine for 4, 15, or
25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be
programmed to run the engine for 9, 20, or 30 minutes (20 minutes default).
Extended Run Time
While the vehicle is running under a remote start,
pressing and holding the
START/STOP
button
for more than 3 seconds
will reset the run time counter to zero and restart the run time cycle from
the beginning. There will be one beep
a pause
three more beeps; the parking lights will flash
three times and the horn (if configured) will honk once.
The extended run time procedure can
only be carried out once per remote start.
To stop the vehicle, at any moment, simply press the
START/STOP
button.
Example:
If your remote car starter is programmed for a run time of 4 minutes and your vehicle
has been running for 3 minutes already, pressing the
START/STOP
button will reset the
counter to zero and allow the engine to run for another cycle (in this case, 4 minutes).
Multi-car Operation
This option allows the owner of two vehicles, both equipped with the same remote starter model, to
control both systems with a single remote control. To control the second vehicle, simultaneously
press the
TRUNK
button and the button of the function you wish to use.
Note:
Your remote control must be configured for second car operation by the installer.
Press
FUNCTION FUNCTION
+
LOCK
:...................................
LOCK
Press
FUNCTION FUNCTION
+
UNLOCK
:..............................
UNLOCK
Press
FUNCTION FUNCTION
+
START/STOP:
...............................
START
Press
FUNCTION FUNCTION
+
START/STOP:
........................
STOP
Troubleshooting Transmitting Range
Many factors may affect the operating range of the transmitter. Some of these are:
•
The condition of the battery in the transmitter.
•
The operating environment (for example: downtown radio-frequency noise, airports, cellular
phone towers…)
•
Metal: any type of metal will affect operating range. This includes the metal in the car.
•
The shape of the vehicle can affect range as well; vans in general have an especially poor
range.
