COMFORTPOOL EasyHeat 2, Руководство пользователя и обслуживания

Страница: 18 / 32

18
Safety warnings & instructions
ATTENTION: This manual includes all the necessary information for the use and
installation of your heat pump.
The installer is responsible for the installation of the product and should follow all the instructions of the
manufacturer and the applicable regulations. Incorrect installation and non-compliance with the
instructions in this manual will void the entire warranty.
The manufacturer declines any responsibility for the damage caused by people, objects and defects
due to incorrect installation, where the instructions in this manual have not been followed. due to the
installation that disobey the manual guideline. Any use that is not conform to that for which the product
was originally manufactured is considered dangerous.
WARNING!
- Failure to follow the safety instructions may result in electric shock, water leaks, fire, damage to the heat
pump or other products, serious injuries or death.
- This is not a TOY. Do not leave children alone and unsupervised around the heat pump.
- Only qualified persons should install the heat pump.
- This heat pump is not intended for use by someone with reduced physical, sensory or mental capabilities,
or a lack of experience and knowledge, unless they have been given instructions concerning the appliance
and are under supervision of the person responsible for their safety.
- Always allow enough space around the heat pump so that there is adequate ventilation capability and keep
it far away from all that could possibly cause a fire.
- Do not use or place the heat pump near toxic substances, flammable or combustible liquids such as
gasoline, or in the presence of explosive or flammable fumes.
- Before the installation, and again before using the heat pump for the first time, the entire product must be
inspected before start-up.
- Do not use the heat pump if any damage is detected. If you notice that the pump does not operate
normally, or emits a strange odor, immediately shut off the power and contact a qualified heat pump
technician.
- Do not attempt to repair of disassemble the heat pump, this will void the warranty.
- Always shut off the power to the heat pump before cleaning of performing maintenance on the heat pump
or water system.
- Always drain the water from the heat pump during winter time, or when the ambient temperature drops
below 0
℃
, frost will damage the titanium exchanger, and this will void the warranty.
- Store the display controller in a dry area, to protect it from being damaged by humidity.
- Refilling the gas may only be done by a professional with a R410A operating license.
- Do not weld the pipe if there is refrigerant in the heat pump. Make sure there is enough ventilation around
the heat pump when refilling the gas.
- Always shut off the power supply if you want to open the cabinet to reach inside the heat pump, because of
the high voltage electricity inside.
- Before filling the pipe of the needle valve with R410A gas, it must be vacuumed.
Above warnings and cautions are not intended to incorporate all possible instances for risks and
injuries.
Owners and users of the heat pump should always exercise caution and common sense when
utilizing the product.