OPERATION
1. Set up cabinet on a level bench top or trolley. Ensure 5cm clearance on all sides of the cabinet.
2. Remove any plastic or foam packaging from the inside and outside of the cabinet.
3. Plug the power cord in at the wall point and turn on
4. Prepare towels. Dampen towels thoroughly with water then wring out excess water. Fold towels or roll into a
cylindrical shape.
5. Place the damp towels into the cabinet, stacking them evenly.
6. Turn the Warming function switch (2) to “ON”. A red light (4) will illuminate to show that the function is working
and the unit is now heating.
7. The towels will be ready to use in approximately 20-30minutes.
8. The UV function may be used by turning the switch (1) to “ON”. A green light (3) will illuminate to show that the
UV function (5) is on.
9. The door should remain closed while the cabinet is in use. Open the door only when adding or removing towels.
10. You must turn both switches to “OFF” at the end of the day.
11. Remove unused towels at the end of the day or when not in use. Start with fresh towels every day.
12. The water drip tray (7) should be detached from the undercarriage of the cabinet and emptied at the end of each
day. (It is attached by a metal clip at each front edge of the undercarriage.)
13. Leave the door open at the end of each day, after the unit is turned off.
PARTS:
1. ON/OFF Switch for UV Function
2. ON/OFF Switch for Warming Function
3. Green Light (Indicated UV Function)
4. Red Light (Indicated Warming Function)
5. Ultra-Violet (UV) Light
6. Towel Rack
7. Water Drip Tray
4
3
2
1
7
5
6
