OPERATING INSTRUCTIONS:
PRE-OPERATING INSTRUCTIONS:
●
Carefully remove your heater from the box (please save the carton for off-season storage).
●
Place heater on a firm level surface.
●
This Heater is not suitable for use in agricultural facilities including areas where livestock, poultry or other
animals are confined. Please refer to National Electric Code (NEC) Article 547-7 (2008), or applicable state
or local codes or standards relating to electrical requirements for Agriculture Buildings.
●
This Heater is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC)
article 500 or applicable state or local codes or standards relating to electrical requirements for Hazardous
locations.
●
WARNING:
REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK – DO NOT USE THIS HEATER WITH
ANY SOLID STATE SPEED CONTROL DEVICES.
●
Plastic or rubber tabs, like the feet on this unit, may stick to furniture surfaces and/or hardwood floors. The
unit may leave a residue that could darken, stain or leave permanent blemishes on the finish of certain
furniture surfaces, including wood surfaces, and /or hardwood floors.
●
Plug the cord set into a 120 volt outlet. The Heater cannot be plugged into a 220 volt outlet.
●
Be sure that the plug fits tightly into outlet. When plugs fit loosely into receptacles, they may slip partially or
completely out of the receptacle with only the slight movement of the attached cord. Receptacles in this
condition may overheat and pose a serious fire hazard. If receptacle and plug are covered by a curtain or
drape, the fire hazard is even greater in this situation.
OPERATING INSTRUCTIONS:
●
Plug the power cord into a wall outlet (120V AC, 60Hz). Connect heater to properly grounded outlets
only.
Power indicator will illuminate
and (- -) will display on the screen of Control Panel.
●
Turn the Heater ON or OFF by pressing (
)
●
Press ON/OFF button (
) once to start the heater, at the same time the 750W indicator lamp will be
illuminated.
(During the heaters initial use, you may experience a slight odor or smoking. This is the result of the heating
element lubrication “burning off”. This is normal and will go away after a few minutes of use.)
●
To select higher 1500 watt setting, press ON/OFF button again. The 1500W indicator lamp will be
illuminated and the 750W indicator lamp will turn off.
●
During the above process, either wattage you select (750W or 1500W), the digital screen will display the
current room temperature in °Fahrenheit.
●
Press the ON/OFF button the third time, the heater will turn off
and
(- -) is displayed on the screen
. Unplug
the Heater from the electrical outlet.
●
Using the Thermostat
●
After turning the heater on, press MODE button repeatedly to cycle through the indicator lights till the TEMP
indicator light is illuminated. You will see (00F) flashing on the screen. At this time, you can use the
UP/DOWN buttons raise or lower the set temperature. Press the MODE button twice to cycle past the timer
feature and exit the temperature setting function or it will save and exit automatically after 15 seconds of
inactivity. The adjustment range of temperature is from
35F to 95F
. When the temperature setting
completed, TEMP indicator lamp will be illuminated to show that the heater is in Thermostat mode. To turn
thermostat off adjust the temperature displayed on the screen to be (00F).
●
Setting the Timer
●
After turning the heater on, press MODE button repeatedly to cycle through the indicator lights till the TIMER
indicator light is illuminated. You will see (00H) displayed on the screen (at this time both TEMP indicator
light and TIMER indicator light may be illuminated). Use the UP and DOWN buttons to set the length of time
you want the heater to run from 1 to 12 hours. When the time setting is completed, you can press the MODE
button again to exit the time setting process or it will save and exit automatically after 15 seconds of
inactivity. At the same time, the TIMER indicator lamp will be illuminated. To turn timer off adjust the length
of time displayed on the screen to be (00H).
●
Using the Thermostat and Timer at the same time
●
You can have the thermostat and timer work at the same time. Follow the instructions “Setting the
Thermostat” in these instructions. Once thermostat is set, as you cycle past the modes using the MODE
button select the timer function when you see (00H) on the display and the timer indicator light illuminated.
Set the time as shown in “Setting The Timer” in these instructions. You can press the MODE button again to
exit the time setting processes or it will save and exit automatically after 15 seconds of inactivity.
●
When overheating occurs, the CAUTION indicator lamp will illuminate and the heater will stop working
immediately.
NOTE
●
When the heater is in the thermostat mode, the TEMP indicator light is illuminated. When the room
temperature exceeds the set temperature of the heater, the heater will stop heating, at the same time the
indicator light of the related power level will be off. When the room temperature is lower than the set
temperature of the heater, the heater will resume heating. Note: If the cable is unplugged, you will need to
set the temperature and the time again when starting the unit next time.
●
When the heater is in the timer setting mode, the timing setting indicator light will be ON. When the unit is
not in the timing setting mode, the timing setting light will be OFF. After the timer has reached its setting, the
TIMER light will turn OFF at the moment the heater will shuts off.
●
AUTOMATIC TEMPERATURE CONTROL The Heater will shut off when ambient air temperature reaches
the temperature you have set. When the air temperature is below the set temperature
, the Heater will turn
on.
●
PET OWNERS NOTE: The health of birds and some small pets are extremely sensitive to the fumes given
off during the initial use of many appliances. Although these fumes are not harmful to humans, it is
recommended that this heater not be used around birds and small pets during its initial use until the
manufacturing corrosion coatings burn off.
TROUBLESHOOTING:
•
Be sure the heater is plugged in and the electrical outlet is working.
•
Check that the thermostat is not set too low.
•
Unplug the heater, wait at least 10 minutes, then re-plug the heater in and follow the
OPERATING
INSTRUCTIONS
.
•
If heater still fails to operate, contact Customer Service for help.
SERVICE INSTRUCTIONS:
•
Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void the
warranty.
•
If you have any questions regarding this unit’s operation or believe any repair is necessary, please call
1-800-221-6895 to speak with a Customer Service Representative.
•
If you need to exchange the unit, please return it, in its original carton with a sales receipt, to the store you
purchased it. If you are returning the unit more than 30 days after the date of purchase, please see the
enclosed warranty.
LIMITED WARRANTY
Products manufactured by Comfort Zone® are warranted to the original consumer to be free of defects in
material and workmanship for twelve (12) months from the original date of purchase. The warranty does not
cover products modified outside our factory, damage or failure caused by acts of God, abuse, misuse, abnormal
usage, faulty installation, failure to follow suggested maintenance procedures enclosed with this product (as
defined by Magnuson-Moss Warranty-Federal Trade Commission lmprovement Act) This unit is guaranteed to
the original retail purchaser against defects in quality or workmanship for a period of one year from the date of
original purchase. If this unit fails because of a manufacturing defect within 30 days of purchase, return the unit,
with your receipt, to the retailer. After 30 days, but within the warranty period, if the unit was purchased within
the continental united States, return it, freight prepaid, to Comfort Zone®. for repair or replacement. If the unit
was purchased outside the continental united States, return the unit to the place of purchase. This warranty
does not cover damage due to accidents, operation on other than 120 volts, 60 hertz, AC. current, or any other
abuse. All implied warranties, including the warranties of merchantability and of fitness of purpose, if applicable,
are hereby limited in duration to the period of one year from the date of original retail purchase. Some states do
not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
Incidental or consequential damages arising from a breach of either express or implied warranties are hereby
disclaimed and excluded. Some states do not allow the exclusion of limitation of incidental or consequential
damages, so this limitation or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
No informal dispute settlement mechanisms are available. This limited warranty is given in lieu of all other
warranties.
