3
3
CZTF320WT | CZTF320BK
www.comfortzoneproducts.com
Usage:
Fan Operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz
wall outlet. Be sure plug fits tightly in outlet. A loose connection
may cause overheating and damage to the plug or fan. NOTE:
To prevent overloading a circuit, do not plug the fan into a circuit
that is servicing other electrical needs.
Step 2
Assemble the two
pieces of the base
with power wire
passing through the
center.
Step 3
Place assembled
base onto the
bottom of the tower
fan and align the
screw openings
to the open screw
holes from assembly
Step #1. Screw
down base using
screws saved earlier.
Power Cord
Fits in
Opening
Turning Fan On/Off:
Place fan on stable level surface.
Plug fan into properly grounded outlet. To start the fan, turn
the control dial clockwise to the desired speed level: 1‑LOW,
2‑MEDIUM, 3‑HIGH. Turn dial to OFF to discontinue use.
Unplug fan when not in use.
Oscillation:
To start the fan with oscillation, turn the control
dial counter‑clockwise to the desired speed level with the
arrow above: 1‑LOW, 2‑MEDIUM, 3‑HIGH. Turn dial to OFF to
discontinue use. Unplug fan when not in use.
Fan Assembly:
Assembly is required to use this fan.
Control Dial
Step 1
Remove and save the
pre‑installed screws
from the underside of
the fan.
On/Off Speed Control
Stationary
fan
Speeds
Fan Speeds
with
Oscillation
Step 4
Place wire
through wire
holders as
shown.
