3
3
CZMC24
www.comfortzone-us.com
Usage:
Fan operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling. FAN CONNECTION: Plug fan directly
into 120 volt A.C., 60 Hz wall outlet. Be sure plug fits tightly in
outlet. A loose connection may cause overheating and damage
to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into a
circuit that is servicing other electrical needs.
Turning Fan On:
Place fan on stable level surface. Plug fan into
properly grounded outlet. To start the fan, rotate the Power Knob
from the OFF position to the desired fan speed HI, MED, LOW.
Turning Fan Off:
To turn the fan off, rotate the Power Knob
from the current fan speed setting to the off position. Remove
plug from outlet.
Adjusting Fan Tilt:
To adjust the angle simply tilt the fan to the
desired position.
Fan Wheel Assembly:
Assembly is required to assemble
wheels. Simply align two Wheel Clips to fan frame and push
them to attach as shown in Fig.1 and Fig.2.
Fig 1
Fig 2
Power
Knob
Care and Maintenance
Cleaning:
CAUTION-Before cleaning the fan be sure to
disconnect power cord from the plug. Clean the grille surface
with a clean damp cloth. Do not use harsh chemical or abrasive
cleaners. DO NOT IMMERSE THE FAN OR ANY WIRES IN
WATER. Replace front grille before fan use. Allow fan to dry
completely before use. Periodic grille cleaning with a vacuum will
prevent dust build up. The motor is sealed and does not require
any interior maintenance, cleaning or lubrication.
Maintenance:
The Internal motor bearings are permanently
lubricated at the factory and do not require any additional
lubrication.
Repair:
DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN
PLACE. DO NOT USE THE FAN IF IT HAS MALFUNCTIONED OR
BECOME DAMAGED IN ANY WAY.
Storage:
Keep original carton for storage of the fan. Coil and tie
the power cord to avoid damage during storage.
