3
3
www.comfortzoneproducts.com
PRODUCT OVERVIEW:
USAGE:
FAN OPERATION:
Always operate the fan in the upright
position following all instructions and recommendations listed
in this manual.
FAN LOCATION:
Place the fan in the area of the room that will
provide proper fan cooling.
FAN CONNECTION:
Plug fan directly into 120 volt A.C., 60 Hz
wall outlet. Be sure plug fits tightly in outlet. A loose connection
may cause overheating and damage to the plug or fan.
NOTE:
To prevent overloading a circuit, do not plug the fan into a circuit
that is servicing other electrical needs.
FUNCTIONS:
TURNING FAN ON/OFF:
To start the fan, press the ON button
on the fan or by pressing the ON/OFF button on the remote
control. To shut the fan off, press the OFF button on the fan or
the ON/OFF button on the remote control.
SPEED SELECTION:
Select your desired fan speed by pressing
the SPEED button on the fan or by using the remote control. The
speed indicator will be illuminated, and the display will show the
speed setting you selected (1‑Low, 2‑Medium, or 3‑High).
OSCILLATION:
Press the OSCILLATION button on the fan or on
the remote control to start the oscillation feature. The oscillation
indicator will be illuminated. To turn off the oscillation function,
press the OSCILLATION button again.
TIMER:
The timer can be set for up to 8 hours by pressing the
TIMER button on the fan or on the remote control. The Timer
indicator will be illuminated, and the display will show the timer
setting you selected. After 3 seconds of displaying the set time,
the display will turn to show the speed setting.
CARE AND MAINTENANCE:
CLEANING:
ALWAYS DISCONNECT THE UNIT FROM THE
POWER SOURCE BEFORE performing any cleaning or
maintenance. Clean the grille surface with a clean damp cloth.
Do not use harsh chemical or abrasive cleaners. DO NOT
IMMERSE THE FAN OR ANY WIRES IN WATER. Allow fan to dry
completely before use. Periodic grille cleaning with a vacuum will
prevent dust build up.
MAINTENANCE:
The internal motor bearings are permanently
lubricated at the factory and do not require any additional
lubrication.
REPAIR:
DO NOT USE THE FAN IF IT HAS MALFUNCTIONED
OR BECOME DAMAGED IN ANY WAY.
STORAGE:
Keep original carton for storage of the fan.
Coil and tie the power cord to avoid damage during storage.
REMOTE CONTROL:
The remote control uses a button cell battery, type CR2025 (3V).
Before using the remote control, you must remove the insulating
film as shown in the figure below.
To remove the battery carriage use your thumb to squeeze the
release tab to the right and then pull the carriage out. Place the
battery into the carriage and slide the carriage back into the
remote. (see
Fig.1
). We recommend the use of a Lithium Ion
battery for longer use.
NOTE:
Follow battery disposal instructions on battery packaging,
or contact your local safety council for safely disposal of
batteries.
1. All functions performed with remote control work identically
to the fan control panel.
2. Aim the remote control at the fan control panel to operate
the fan.
Remote Control
Status Display Window
Timer
Indicator
Speed
Indicator
Oscillation
Indicator
Speed Setting/
Timer Setting Display
Front
Cover
Fan
Blades
Status
Display
Window
Speed
Button
Oscillating
Button
Timer
Button
Pull
Insulating Film
Battery
Carriage
Release Tab
Push to Open
