3
3
www.comfortzoneproducts.com
USAGE:
Fan Operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz wall
outlet. Be sure plug fits tightly in outlet. A loose connection may
cause overheating and damage to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the
fan into a circuit that is servicing other electrical needs.
Turning Fan On/Off:
To start the fan, turn the control dial
clockwise to the desired speed level: 1‑LOW, 2‑MEDIUM,
3‑HIGH. Turn dial to OFF to discontinue use. Unplug fan
when not in use.
OSCILLATION:
To start the fan with oscillation, turn the control dial
counterclockwise to the desired speed level with the
arrow above: 1‑LOW, 2‑MEDIUM, 3‑HIGH. Turn dial
to OFF to discontinue use. Unplug fan when not in use.
Fig 1
Slide Cover to Open
Fig 2
Fig 3
OFF
OFF
OSC
Control Dial
CARE AND MAINTENANCE:
Cleaning:
CAUTION‑Before cleaning the fan be sure to
disconnect power cord from the plug. Clean the grille surface
with a clean damp cloth. Do not use harsh chemical or abrasive
cleaners. DO NOT IMMERSE THE FAN OR ANY WIRES IN
WATER. Allow fan to dry completely before use. Periodic grille
cleaning with a vacuum will prevent dust build up. The motor is
sealed and does not require any interior maintenance, cleaning or
lubrication.
Maintenance:
The Internal motor bearings are permanently
lubricated at the factory and do not require any additional
lubrication.
Repair:
DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN
PLACE. DO NOT USE THE FAN IF IT HAS MALFUNCTIONED OR
BECOME DAMAGED IN ANY WAY.
Storage:
Keep original carton for storage of the fan. Coil and tie
the power cord to avoid damage during storage.
Note
: Some models come with a plug where you can replace a
fuse. If your model has this, please read and follow the below
instructions to replace the fuse.
This product employs overload protection (fuse). A blown fuse
indicates an overload or short‑circuit situation. If the fuse blows,
unplug the product from the outlet. Replace the fuse as per the
user servicing instructions (follow product marking for proper
fuse rating) and check the product. If the replacement fuse
blows, a short‑circuit
may be present and the product should
be discarded or returned to an authorized service facility for
examination and/or repair.
Fuse Replacement:
1. Grasp plug and remove from the receptacle or other outlet
device. Do not unplug by pulling on cord.
2. Open fuse cover by sliding open fuse access cover on top of
attachment plug towards blades. See Fig. 2
3. Remove fuse carefully. Use a small tool to pry the end of the
fuse from holder cavity. Be careful not to break glass window.
4. Replace fuse.
WARNING:
Risk of fire. Replace fuse only with identical 2.5
or 5.0 Amp, 125 Volt fuse (3.6mm x 10mm). Be sure fuse is
properly seated within its cavity.
5. Close fuse cover by sliding it back to its original closed
position.
