3
3
SETTING THERMOSTAT:
After heater has been turned on and
the room has reached the desired temperature, slowly rotate
the thermostat knob counter-clockwise until the heater shuts
off (you should hear a faint “click”). By leaving the thermostat
at this setting it will automatically maintain this temperature. To
lower the temperature, rotate the knob further counter-clockwise
(towards the LOW position). To raise the temperature, rotate the
thermostat knob clockwise (towards the HIGH position).
TURNING OFF:
Turn the center dial to the OFF position
before unplugging or plugging in the heater. Heater should be
unplugged when not in use.
TO OPERATE FAN ONLY:
Turn the On/Off Power Level Control
dial to the Fan setting. Turn thermostat fully clockwise so the fan
will run continuously.
IMPORTANT SAFETY FEATURES:
The power indicator light, located near the control panel, lights
whenever the heater or fan is turned on. The heater is equipped
with an automatic overheat protection device located inside
the body of the heater. If the heater grille is obstructed, or if
the heater gets too hot for any reason, the automatic overheat
protection device will turn the heater off. To reset the heater,
simply turn power off and unplug the heater for 10 minutes until
it cools down and then you may plug the heater in and restart.
Be sure that the heater is on a smooth level surface with no
obstructions. The heater is also equipped with a safety tip-over
switch to turn power off to the heater when the heater tips over.
To resume heater functions simply stand heater upright.
USAGE:
HEATER OPERATION:
Always operate the heater in the upright
position following all instructions and recommendations listed
in this manual.
HEATER LOCATION:
Place the heater in the area of the room
that is coldest.
HEATER CONNECTION:
Plug heater directly into 120 Volt AC,
60Hz wall outlet. Be sure plug fits tightly in outlet. A loose
connection may cause overheating and damage to the plug
or heater.
NOTE:
To prevent overloading a circuit, do not plug the heater
into a circuit that is servicing other electrical needs.
POWER INDICATOR:
When the unit is turned on, the power
indicator light will illuminate to tell you the heater is functioning.
TURNING HEATER ON:
To start the heater, turn the Power
Control dial from OFF position to FAN, LOW, HIGH, or ENERGY
SAVE setting. Then, rotate the Thermostat Control clockwise to
the HIGH THERMOSTAT position as described below. (During the
heaters initial use, you may experience a slight odor or smoking.
This is the result of the heating element lubrication “burning off”.
This is normal and will go away after a few minutes of use.)
POWER LEVEL SWITCH:
This heater has 3 heat settings:
ENERGY SAVE, HIGH, and LOW. Select the heat setting that
best meets your heating needs. The ENERGY SAVE heat setting
provides comfortable heating in most rooms, while saving you
money on energy costs.
CONTROL PANEL
Power
Indicator
Thermostat
Control
Oscillation
Control
ON/OFF
Power Level
Control
