3
3
www.comfortzoneproducts.com
USAGE
HEATER OPERATION:
Always operate the heater in the upright
position following all instructions and recommendations listed in
this manual.
HEATER LOCATION:
Place the heater in the area of the room
that is coldest. The heater should not be placed immediately
under a power outlet.
HEATER CONNECTION:
Plug heater directly into 120 Volt A.C.,
60Hz wall outlet. Be sure plug fits tightly in outlet. A loose
connection may cause overheating and damage to the plug or
heater.
NOTE:
To prevent overloading a circuit, do not plug the heater
into a circuit that is servicing other electrical needs.
UNPACKING YOUR HEATER:
Carefully remove your heater
from its packaging. This heater has plastic or rubber feet to help
keep the heater quiet and vibration free. These feet may leave a
residue that could darken, stain or leave permanent blemishes on
the finish of certain furniture surfaces, including wood surfaces
and/or hardwood floors.
TURNING HEATER ON
To start the heater, turn the On/Off Power Switch from the
OFF
«O»
position to the ON
«—»
position.
During the heaters initial use, you may experience a slight odor
or smoking. This is the result of the heating element lubrication
"burning off". This is normal and will go away after a few minutes
of use.
POWER SWITCH:
on the back panel of heater
TURNING HEATER OFF
Turn the On/Off Power Switch to the OFF
«O»
position before
unplugging or plugging in the heater. Heater should be
unplugged when not in use.
IMPORTANT SAFETY FEATURES
The power indicator light, located behind the safety grille, lights
whenever the heater is plugged in to live power.
The heater is equipped with an automatic overheat protection
device located inside the body of the heater. If the heater grille
is obstructed, or if the heater gets too hot for any reason, the
automatic overheat protection device will turn the heater off.
To reset the heater, simply turn power off and unplug the heater
for 10 minutes until it cools down and you may plug the heater
in and restart the heater. Be sure that the heater is on a smooth
level surface with no obstructions.
POWER INDICATOR:
Once the unit is plugged into the wall outlet
and the power switch on the back of the unit is switched on
«—»
,
the power indicator light will illuminate.
Power Indicator Light
ON OFF
