3
3
www.comfortzoneproducts.com
USAGE
HEATER OPERATION:
Always operate the heater in the upright
position following all instructions and recommendations listed in this
manual.
HEATER LOCATION:
Place the heater in the area of the room that
is coldest. The heater should not be placed immediately under a power
outlet.
HEATER CONNECTION:
Plug heater directly into 240 Volt AC,
60Hz, 25A wall outlet. Be sure plug fits tightly in outlet. A loose
connection may cause overheating and damage to the plug or heater.
NOTE:
To prevent overloading a circuit, do not plug the heater into a
circuit that is servicing other electrical needs.
TURNING HEATER ON
To start the heater, turn the heater ON by turning the Power Knob
(located on the top of the heater) away from the OFF «
0
» position to the
FAN ONLY
setting or to the HEATING
setting.
For faster heat up or to increase the heat output, turn the THERMOSTAT
CONTROL knob all the way to the
MAX
(maximum) position.
The thermostat function controls the temperature output. To decrease
the heat output, turn the knob towards the
MIN
(minimum) position.
NOTE:
During the heaters initial use, you may experience a slight odor
or smoking. This is the result of the heating element lubrication "burning
off". This is normal and will go away after a few minutes of use.
POWER
LIGHT
Fan Only
OFF
0
Heating
& Fan
DO NOT COVER
3.6 kW
HEAT SETTING:
This heater has one heat setting –
HIGH
(3,600W) with heat output of 12,300 BTU per hour.
SETTING THERMOSTAT:
First turn the thermostat to
MAX
and let
the heater operate with full power input. When the room reaches the
desired temperature, turn the thermostat towards
MIN
until it switches
off. The thermostat will then switch on and off automatically to control
the room temperature according to the preset level and keep the room
temperature constant.
TURNING HEATER OFF
To completely shut off the heater, turn the POWER KNOB to
the OFF «
0
» position and unplug the heater. Heater should be
unplugged when not in use.
CONTROL PANEL
Thermostat Control
( Temperature Knob )
Power Knob
( Power and Fan Switch )
PARTS OF THE HEATER
FRONT OF HEATER
BACK OF HEATER
1) Carry Handle
2) Control Box
3) Heating Element
4) Lower Part of Tube Base
5) Pipe Rack Connection
6) Adjusting Tilt Knob
7) Power and Fan Switch
8) Temperature Control Knob
9) Air Intake
10) Motor
11) Fan
MAX
MIN
