3
3
CZ122BK
www.comfortzoneproducts.com
Usage:
Fan Operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan Connection:
Plug fan directly into 120 volt A.C., 60 Hz
wall outlet. Be sure plug fits tightly in outlet. A loose connection
may cause overheating and damage to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into
a circuit that is servicing other electrical needs.
Turning Fan On/Off:
Place fan on stable level surface. Plug
fan into properly grounded outlet. To start the fan, rotate the
Knob: 0, 3‑HIGH, 2‑MED, 1‑LOW. Press 0‑OFF to discontinue
use. Unplug fan when not in use.
Oscillation:
To start fan oscillation, press Oscillation Control
Knob (located above motor housing) down.
To stop oscillation function pull Oscillation Control Knob up while
the fan is in any oscillation position.
Fan Assembly:
Assembly is required to use this fan.
Alignment Pins
Place the base
of the Fan on a
flat surface.
Align the clips of the fan shaft to
the notches in the hole on the
base.
Step 4
Remove the Blade Cap by twisting it CLOCKWISE while
holding the metal shaft tightly.
Note: Threads are reversed. Unscrew = Clockwise.
L
oo
se
n
Power and
Speed Control
Rotary Knob
Control
Panel
Oscillation
Control Knob
Step 2
Step 3
Press down and snap the shaft
into the base of the fan.
4 Fan
Shaft Clips
4 Fan Base
Notches
Step 9
Step 7
Step 5
Step 8
Step 6
Remove any protective
covering over shaft before Fan
Blade Installation. Place Fan
Blade onto Motor Shaft. Notice
the pin on Motor Shaft should
fit into slots of Fan Blade.
Assemble Rear Grille onto Motor
Housing. Rear Grille should fit into
pins on fan motor housing as shown.
Thread Blade Cap onto
threaded end of Motor Shaft.
Note: Threads are reversed.
Tighten = Counter-clockwise.
Thread Locknut onto Motor
Housing to lock Rear Grille
in place.
With logo upright, attach Front
Grille to Rear Grille by snapping
them together. Be sure all 8 clips
are secure. Do not operate fan
without grille in place.
T
i
g
hte
n
Pin
Pin
Pin
Slot
Lock-Nut
Pin
Step 1
