Comfort Heat C 101, Руководство пользователя, Страница: 7 / 30

7
4. SENSOR INSTALLATION
The thermostat sensor is placed in a conduit which is embedded
in the concrete floor. The conduit end is sealed and placed in the
concrete layer as close to the surface as possible. The sensor
cable can be extended up to 50 m by means of separate cable.
5. TEMPERATURE SETTINGS
The electronic thermostat C 101 has a scale range of +5/+45°C.
The temperature control knob is used to set the required
temperature. The graduations of the thermostat scale
correspond to an actual temperature. Red LED indication
informs that the heating is on. The thermostat should be set to
maximum temperature setting until the desired temperature
of the room or floor is achieved. The control knob should then
be turned back until the LED goes out. Fine adjustments can be
made over the following 1-2 days to suit individual requirements.
Setback temperature is energised by remote timer ( Pic. 3 ).
Setback temperature is 5°C below the set temperature.
6. THERMOSTAT ADJUSTMENT
When the room temperature has been stabilised, the thermostat
set position may be adjusted to match actual room temperature.