-5 -
ASSEMBLY INSTRUCTIONS
NOTE:
A complete electric fireplace heater should consist of two parts: the wooden mantel and the
fireplace heater each packed in a separate carton. It is not recommended to use the fireplace
heater without the wooden mantel. Unpack the fireplace heater and mantel. Remove all packing
materials.
WARNING:
Make sure the fireplace INSERT controls are in the OFF position and the INSERT is
NOT plugged in.
CAUTION:
Place a piece of cardboard or protective sheet on the floor in order to avoid scratching
the decorative surface of your mantel during assembly.
Please
DO NOT
fully tighten the KD screws until all panels are assembled.
Step 1: Attach all
PLASTIC CONNECTORS
(X) to the
PANELS
(C, D, &E) as shown in Figure A. (2
screws for each
PLASTIC CONNECTORS
.)
PARTS LIST:
A)
Top panel
1
B)
Base panel
1
C)
Side panel
2
D1) Left front panel
1
D2) Right front panel
1
E)
Upper front panel
1
F)
Lower front panel
2
G)
Small front panel
1
T)
Short KD screws
5
U)
Mounting clips
3
V)
Mounting brackets
2
W)
KD screws
53
X)
Plastic connector
15