3
104341
OWNER’S MANUAL
PRODUCT
IDENTIFICATION
Figure 1 - Vent-Free Gas Log Heater - Dual Burner (Logs May Vary by Model -
Yellow Flame Model Shown)
LOCAL CODES
Install and use heater with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANSI Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Operation
This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
realistic dancing, yellow flames. This heater
is designed for vent-free operation with flue
damper closed. State and local codes in
some areas prohibit the use of vent-free
heaters. You can operate non-thermostat
heater as a vented product by opening flue
damper.
Safety Pilot
This heater has a pilot with an Oxygen
Depletion Sensor Shutoff System (ODS).
The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off
the heater if there is not enough fresh air.
Piezo Ignition System
This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.
PRODUCT
FEATURES
UNPACKING
1.
Remove logs and heater base assem-
bly from carton.
Note:
Do not pick up
heater base assembly by burners. This
could damage heater. Always handle
base assembly by grate.
2.
Remove all protective packaging ap-
plied to logs and heater for shipment.
3.
Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.
Front Log
Control Knob
Back Log
Base Grate
Burner
Piezo
Ignitor
Crossover Log
Middle Log
Note:
Where listed vented decorative logs
are required, thermostat operation is not
permitted.
Front Log
Control Knob
Back Log
Burner
Piezo
Ignitor
Crossover Log
Figure 2 - Vent-Free Gas Log Heater - Single Burner (Mountain Oak Model Shown)
