22
CAST IRON STOVE AND BURNER SYSTEM
105501
CDVBN(A) AND CDVBP(A)
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
freestanding burner system. Do not use if
any log(s) are broken (see Replacement
Parts, page 30).
1.
Remove glass door. See Removing/Re-
placing Glass Door, page 21.
2.
Place log #1 (back log) on top of grate.
Make sure the notches in the bottom of
the log fit over the grate (see Figure 51).
3.
Rest log #2 (large front log) on the pins on
the front part of the grate (see Figure 52).
4.
Place log #3 (left piece) onto the front
left part of the grate. Make sure it is
seated properly over the prong of the
grate as shown in Figure 53.
WARNING: Failure to posi-
tion the parts in accordance with
these diagrams or failure to use
only parts specifically approved
with this burner system may re-
sult in property damage or per-
sonal injury.
INSTALLING LOGS, LAVA
ROCK AND GLOWING
EMBERS
STOVE AND
DIRECT-VENT
BURNER SYSTEM
INSTALLATION
Continued
1
2
3
4
Figure 51 - Installing Log No. 1
Figure 52 - Installing Log No. 2
Figure 53 - Installing Log No. 3
Figure 54 - Installing Log No. 4
WARNING: The glass door
must be securely in place before
running this burner system. Do
not run this burner system if glass
is missing or broken.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner could cause
performance problems.
5.
Place log #4 (right piece) onto the front
right part of the grate making sure the
notches fit over the prong of the grate
(see Figure 54).
Figure 55 - Placing Ember Material on
Burner
6.
Place lava rock along sides and front
of inside of burner system bottom. It is
not necessary to use all of the lava rock
provided.
7.
Pull ember material apart into pieces
no larger than a dime. Place these
pieces loosely and sparingly directly
onto the exposed section of the front
burner and along the space between the
burner and grate prongs (see Figure 55).
This will create the glowing ember ap-
pearance as the flame touches the em-
ber material. Do not block air slots by
using too much ember material in one
area. It is not necessary to use all of the
ember material provided.
8.
Replace the glass door and stove front.
See Removing/Replacing Glass Door,
page 21.
