17
107123
OWNER’S MANUAL
For more information, visit www.desatech.com
Single Burner Mountain Oak
Models
INSTALLATION
Continued
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1.
Place the back log (#1) onto the back
of the burner. Make sure the log sits
down into the hole in the grate and leans
forward onto the two posts in front of
the log (see Figure 35).
2.
Locate the notches on the underside of
the front log (#2). Also notice the re-
cesses on the back of log #2. Slide the
notches over the tabs on the grate base
and the front posts into the recesses on
the back (see Figure 36).
3.
Place the crossover log (#3) on top of
the back log and front log. Make sure
the crossover log is seated into the
notches on top of the back and front
logs (see Figure 37).
4.
Add lava rock around base of heater.
Do not put lava rock on logs or burner.
Figure 35 - Installing Back Log
Crossover
Log (#3)
Figure 36 - Installing Front Log
Front Log
(#2)
Notch
Notch
Tabs on
Grate Base
Notch
Figure 37 - Installing Crossover Log
Back Log (#1)
Recess
Post
Hole in
Grate
Post
7
6
Figure 33 - Installing Crossover Log (#6)
(CCL3930NTA Shown)
Figure 34 - Installing Crossover Log (#7)
to Model CCL3930NTA Only
Pegs
Log #2
Front Log (#1)
Middle
Log (#2)
Crossover
Log (#6)
Holes
Pegs
32.
6.
Locate holes on the bottom of cross-
over log (#6). Slide these holes onto the
right pegs located in middle log (#2)
and front log (#1). See Figure 33.
7.
For CCL3930NTA only:
Locate holes
on the bottom of crossover log (#7).
Slide onto the pegs located in crossover
log (#6) and middle log (#2). See Fig-
ure 34.
8.
Add lava rock around base of heater. Do
not place any lava rock on logs or burner.
