Programmer DT05
6
Pairing
When
Pairing is selected, the DT10 can be set to pairing
mode by pressing the push-button for two seconds.
If
Pairing isn’t selected, pairing mode cannot be enabled
with the push-button. To override this, (if the Receiver
DT10 needs to be reconfigured or if new pairing infor-
mation needs to be received), press and hold the push-
button on the Receiver DT10 for 2 seconds within
10 seconds of it having been connected to a hearing
instrument or a Programmer DT05. This sets the
Receiver DT10 to Pairing mode and it is then ready to
receive new settings from the Programmer DT05.
The Receiver DT10 can receive but not transmit pairing
information. To pair the Receiver DT10 with your
Comfort Digisystem transmitter the Receiver DT10 must
be connected either to your hearing instrument
or to the Programmer DT05.
If you enable
Always on and at the same time disable
Pairing, the push-button on the Receiver DT10 becomes
inoperable.
Always on
The setting
Always on, disables the off-function of the
push-button, leaving the Receiver DT10 always on. The
Receiver DT10 is turned off when turning off the Hearing
aid.
Send all
To configure a Receiver DT10 with all settings in the
display of the Programmer DT05 select
Send all. If you
choose
Send all, you will receive the warning “All set-
tings in DT10 will be overwritten”. Only select
Yes if you
want to overwrite all data in your Receiver DT10.
Settings
HA scanner
The Frequency scanner is used for detecting how
much interference there is from a hearing aid,
within the frequency band that the Receiver DT10
is operating in.
Language
For selection of menu language.
Factory Reset
DT05: Resets the Programmer DT05 to its default
settings.
DT10: Resets the Receiver DT10 to its default
settings, which means that also all pairing
information is deleted. The Receiver DT10 must be
set to pairing mode in order to be reset.
To prevent eaves-dropping a new code key must be
generated.
About
Software information.
Example:
Make a new eavesdrop secure configuration
with one Microphone DM10 and two Receiver DT10s
using the Programmer DT05:
1. Put one of the Receiver DT10s into the Programmer
DT05.
2. Start the Programmer DT05 and connect head
phones or a neck loop to be able to listen.
3. Activate pairing mode for the DT10 by pressing the
push-button for 2 seconds.
In the headphones/neckloop you receive an acoustic
indication:
•
•
4. Start the Microphone DM10 and open the menu.
Select
Communication/Pairing/New code key and
answer
Yes if you want to create a new code key and
transmit it.
5. The Receiver DT10 confirms success-
ful pairing with an acoustic indication:
• •
6. Remove the paired DT10 and connect the other
DT10 into the Programmer DT05.
7. Activate pairing mode on the DT10 by pressing the
push-button for 2 seconds.
In the headphones/neckloop you receive an acoustic
indication:
•
•
8. Open the menu on the DM10 and select
Communication/Pairing/Send info.
9. The Receiver DT10 confirms success-
ful pairing with an acoustic indication:
• •
