14
Installation, Operation & Maintenance
PSH-141A
AITONS EQUIPMENT
CARE AND MAINTENANCE
CARE AND MAINTENANCE
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, paint thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired by
an authorized servicer.
IMPORTANT:
1. Air filter
2. Unit Cabinet
- Use a lint-free damp cloth with neutral detergent to clean
the cabinet. Finished by drying with a clean, dry cloth.
Fig.21
3. Unit storage when not in use
- Remove the rubber plug at the back of the unit and attach
a hose to the drain outlet
. Place the open end of the hose
directly over the drain area in your basement floor
(See Fig.18 & 19).
- Remove the plug from the bottom drain outlet, all the water
in the bottom tray will drain out (See Fig.21).
- Keep the appliance running in FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold
from forming.
- Stop the appliance and unplug it, wrapped the cord and
bundle it with the buckle and plug the power plug into the
socket on the back of the unit. (Fig.23). Remove the batteries
from the remote controller.
- Clean the air filter and reinstall it.
- Unscrew the exhaust hose from the unit and pull out for
uninstallation (Fig.24).
Fig.22
Fig.23
Buckle
Power
cord
Upper filter
(take out)
Remove the
screw ,then
take the lower
filter out.
Upper filter
(install)
Install the lower
filter by using
the screw.
- Clean the air filter at least once every two weeks.
- Removal
This unit has two filters. Take the upper filter out along the
the arrow direction (Fig.21),then take the filter down.
Remove the lower filter by loosening the screw, taking out
the filter as shown in Fig.21.
- Cleaning
Wash the air filter by immersing it gently in warm water
O
O
(about 104 F/40 C) with a neutral detergent. Rinse the filter
and dry it in a shady place.
- Installation
Insert the upper air filter after cleaning, and reinstall the lower
filter by using the screw (see Fig.22).
Power plug
socket
Power plug
Fig.24
