IMPORTANT: Read through the emitter replacement
procedure below before beginning the replacement.
CAUTION: Do not touch emitter with bare hands.
Wearing soft cotton gloves is highly recommended.
1. Turn OFF power switch and disconnect from
main power supply (circuit breaker).
2. Be sure the heater and emitter are cool com-
pletely,: burns can result from touching hot com-
ponents.
3. Remove the screws from the end of the heater
fixture and remove the aluminum end cap.
4. Carefully slide the perforated front grille imme-
diately adjacent to the end cap off the end of the
unit.
5. Carefully slide the protective grille to the end of
the heater to expose the emitter and silicone
sealing connectors.
6. Carefully remove the emitter and silicone wire
connectors from the aluminum emitter clips, free-
ing the wire/connector system.
7. Carefully remove the silicone terminal connectors
from the ends of the emitter. Be careful not to
break the emitter terminal end inside the silicone
wire connector. Discard the used emitter.
8. Holding the new emitter by the ceramic ends OR
wearing clean dry gloves, place the silicone ter-
minal connectors onto the new emitter and re-clip
it into the emitter holder.
9. Carefully slide the protective grille and perforated
end cap into place, and replace screws.
MAINTENANCE
There are only two maintenance procedures which
can be done on location: cleaning the unit and
replacing the emitter. Return the heater to an au-
thorized service faciity for any other electrical or
mechanical adjustment or repair, including replace-
ment of a damaged power cord.
Should the heater be dropped or damaged, or mal-
function at any time, immediately turn off the main
power source and do not use heater until it has been
examined by an authorized service facility.
CLEANING
To remove dust or dirt on the reflector, follow these
steps: Always make sure the unit has cooled com-
pletely, before performing any maintenance.
1. Turn the power switch OFF and disconnect heater
from the main power supply.
2. Remove the wire guard and carefully wipe the
reflector with a soft, lint-free cloth.
CAUTION: Do not touch the emitter. Finger marks
will burn into the quartz emitter during use and
cause premature heater failture.
If emitter is inadvertently touched, or if it needs to be
cleaned, carefully wipe it using rubbing alcohol or
methylated spirits.
REPLACING EMITTER
Contact your distributor for the correct replacement
emitter, providing the model number and rating from
the rating label. Not using an exact replacement
emiitter can cause the heater to fail.
Installation & Operation
Radiant Infrared Heater
Heat Controller
4
