the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to defeat this safety featu
re.
WARNING:
1. To reduce the risk of fire or electrical hazard, do not use this fan
with any solid state speed control device.
2. Unplug or disconnect the fan from the power supply before
servicing or cleaning.
HOW TO OPERATE:
1. Set fan on a level and dry surface.
2. Plug the power cord into a standard 120-volt. Ac wall outlet.
3. To operate the switch knob to the desired speed, high, medium or
low.
4. Turning unit around may reverse air direction.
5. press speed key to set the desired speed, low
“
I,
”
medium
“
II”, ..high
“
III
”
.
6. press
“
o
”
key to turn the fan off.
HOW TO ASSEMBLE:
1. Unscrew the 4 screws from the base 2 bars, attach the column to
the bar base with four screws. Remove the height adjustment
control collar and slide the column base cap down over the base
bars. Replace the height adjustment control collar.
2. Insert the fan body onto the slide pipe. Tighten the set knob firmly.
3. Unscrew the plastic collar nut from the motor by turning
counterclockwise.
4. Mount the rear guard to the motor front cover by matching the 3
holes on the rear guard to the 3 round pins on the motor front
cover, push in firmly until the 3 pins protrude through the 3 holes.
5. Tighten the rear guard with the plastic collar nut, be sure that the nut
is screwed in far enough so it will be flush with the outside of the
motor housing cylinder.
6. Insert the fan blade onto the motor shaft by matching the slots of
the blade with the shaft, tighten the blade with the blade cap by
turning it counterclockwise.
7. Test fan by rotating with your hand, make sure there is no contact
with the nut. The fan blade should rotate freely. Otherwise repeat
all steps again, beginning with step 3.
8. Mount front guard onto rear guard by the hook clip of front guard
over rear guard and secure with clips on the front guard.
OSCILLATION:
1. The oscillation knob is located on the top of the motor housing.
Simply press knob down to start oscillation. And lift knob up to stop
oscillation.
NOTES ABOUT CLEANING BLADES:
1. Always unplug the fan before cleaning. simply lift the clips on ring
of the guards and remove the front guard.
2. Use a soft cloth, moistened with a mild soap, to clean fan and
guard. DO NOT use abrasive cleaners.
3. DO NOT immerse fan in water and never allow water to dip into the
motor component.
4.
DO NOT use gasoline, thinner or other chemicals to clean the fan.
