2
WARNING
•
TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK,
DO NOT USE THIS FAN WITH ANY SOLID STATE SPEED
CONTROL DEVICE.
•
UNPLUG OR DISCONNECT THIS FAN FROM THE POWER
SUPPLY BEFORE SERVICING.
ASSEMBLY INSTRUCTIONS:
1. Unscrew
the
Height Adjustment Control Collar
from the
Outer Pipe
by turning
counter-clockwise, and set aside. Pull out the
Inner Pipe
all the way to the top.
(you may have to push it up from the bottom to get it up)
2. Set the base on a level dry surface remove the screws from the
Base Cross Legs
,
then install the
Outer Pipe
and match the 4 holes over the 4 screw holes on the
base and replace the 4 screws back onto the cross leg bars.
3. Place
the
Base Cover
on through the column with the tabs/slots pointed
downward.
4. Replace
the
Height adjustment Control Collar
and tighten by turning clockwise.
5. Place the switch box/fan motor into the top of the inner pipe, tighten the
Set
Screw
.
6. Unscrew
the
Grill Nut
on the front of the motor by turning counterclockwise.
7. Mount
the
Rear Grill
to the motor front cover by matching 3 holes on the guard to
the 3 round positioning knobs on the motor front cover. Push in firmly until the 3
knobs protrude through the 3 holes.
8. Replace and tighten the
Grill Nut
by turning nut clockwise to hold the
Rear Grill
in
place.
9. Put
the
Fan Blade
onto the motor shaft by matching the shafts slots with the
blades slot, tighten the
Blade
with
Blade Cap
by turning it counterclockwise.
10. Test fan by rotating with your hands, make sure there isn’t any contact with the nut.,
the fan blade should rotate freely, otherwise repeat all steps again, beginning from
step(4).
11. Mount
Front Safety Grill
onto
Rear Grill
by hanging the top hook clip of front
guard over the top of the
Rear Grill
. Close the clasps all around the grill.
OSCILLATION:
The oscillation knob is located on the top of the motor housing, simply press the knob down to
start oscillating, and pull the knob up to stop oscillating
OPERATION:
.
1. Set the fan on a level dry surface.
2. Plug the power cord into a standard AC wall outlet.
3. Press speed key to set the desired speed “HI” “MED” “LOW”.
4. Press“OFF”key to turn the fan off.
5. To start or stop fan head oscillating, press or pull the oscillating knob on the top of
the motor housing.
6. To change the air flow angle, move the head forward or backwards.
NOTES ABOUT CLEANING BLADES:
1. Always unplug the fan before cleaning, simply lift the clips on ring of the guards and remove
the front guard.
2. Use a soft cloth, moistened with a mild soap, to clean fan and guard. DO NOT use abrasive
cleaners.
3. DO NOT immerse fan in water and never allow water to dip into the motor component.
4. DO NOT use gasoline, thinner or other chemicals to clean the fan.