5
Setup and Operation
When setting up your heating wrap,be sure to follow these steps in order.
1. Place the Heating Wrap on the shoulder and buckle the button on the armband.(
Img.1
)
2. Tie the straps in front of the abdomen.(
Img.2
)
3. Connect the power cable to the connector on the heated wrap. To connect the cable
to the connector, align the connector and cable arrows and push gently until it locks.
CAUTION:
The cable must be fully plugged in. A loose connection could cause a fire
hazard.(
Img.3
)
Note:
4. Plug the power cord into an electric outlet(120V/60Hz).
5. Make sure all cords are tangle free and not trapped or pinched in any way.
6. Do not wrap the controller in the heated product while in use.
7. Do not use with generator power.
8. Turn on the device by operating the controller (refer to controller instructions.).
9. To disconnect the controller, first unplug the cord from the outlet, then pinch sides of
the connector and pull apart.
• The device will automatically switch off after 90-minute timer runs out.
• Do not setup or use the device in a bathroom or similary wet/damp areas.
• CAUTION: Always turn off the device and disconnect the power cord from the outlet
when not in use
One Button Control:
Press to turn on the device, the device
will default to the low setting, continue to
press the button to select the heat
at Low/Mid/High Level, the
corresponding indicator will light on.
To turn off the device, press the button
until no light is visible on the controller.
High
Mid
Low
Img.1
Img.3
Img.2
Controller instructions
