Comet static 1700, Инструкция по эксплуатации

Страница: 16 / 36

16 16
STANDARD FITTINGS
Make sure that the following parts are included in the packaging of the purchased product:
• High pressure water cleaner.
• Hose reel complete with 10 m (
CLASSIC
) or 20 m (
EXTRA
) of high pressure delivery hose.
• Water gun.
• Spray gun hose.
• Rotating spray nozzle pipe (
EXTRA
).
• Foam spray nozzle.
• Rotating high water cleaning brush (
EXTRA
).
• Wall-mounting kit complete with securing nuts, screws and wall-plugs.
• Right and left safety hooks complete with stop rings.
• Wall-mounted accessory frame, complete with securing screws and wall-plugs.
• Hose reel handle.
• Handle complete with securing screws.
• Suction kit for use on walls, made up of gaskets, filter and quick-release fitting.
• Suction kit for use on the ground, made up of gasket and curved hose holder fitting.
• Instruction manual – Safety warnings.
• Instruction manual – Use and Maintenance.
• Guarantee certificate.
• Service centre booklet.
• Key for disassembling the nozzle.
• Nozzle cleaning pin.
If there are problems, contact your dealer or an authorised assistance centre.
OPTIONAL ACCESSORIES
The following range of accessories can be added to the standard high-pressure cleaner
equipment:
• Rotating spray nozzle pipe: designed to remove stubborn dirt.
• Sanding spray nozzle pipe: designed to sand down surfaces, to eliminate rust, paint settled
dirt etc.
• Rotating high pressure cleaning brush: designed to clean delicate surfaces.
• Fixed high pressure cleaning brush: designed to clean delicate surfaces.
• Hose purging probe: designed to unclog hoses and pipelines.
• Floor washing spray gun: designed to clean tiled floors and walls.
• Hose cleaning-guide kit: designed to wind-up the delivery hose easily and to clean it.
• Wheel kit: designed to make it easier to move the high pressure water cleaner around
when taken off the wall.
• 10 m extension kit of the delivery hose: designed to increase the reach of the high pressure
water cleaner.
INSTALLATION – FITTING ACCESSORIES
• Insert the handle and press right down (2), then secure it with the two screws supplied
(35).
See FIG. 4.
• Insert the hose reel handle until it clicks into place (15).
See FIG. 3.
• Screw the high pressure hose fitting on the thread of the water gun (24) and tighten firmly
with two 17-mm/0.67” fixed jaw spanners (not supplied).
ILLUSTRATED in FIG. 8.
• Insert the filter (18) in the water inlet fitting (17). Insert the gasket (26) in the quick-release
water inlet fitting (25) and screw it on tight onto the fitting (17).
See FIG. 1.