SKETCH 1
SKETCH 3
SKETCH 4
SKETCH 6
Spacer A
10mm x 10mm
Spacer B
10mm x 6mm
Spacer C
6mm x 6mm
Spacer D
6mm x 3mm
Brake hanger holes
GB4/15
gearbox
Mashima
MHK1015
motor
D
B
D
Brake pivot hole
SKETCH 5
To split the rods over the centre crankpin cut the backing rod at A-A, solder to the
corresponding halves of the outer rods and connect both halves at the centre
crankpin.
To split the rods on the knuckle joint first drill through the half-etched centres on
the knuckle and cut the backing rod at B-B. Solder the inner and outer halves
together then join the front and back halves of the rods using a pin or rivet (not
supplied) so that the rods are articulated behind the centre crankpin.
Front half
A
A
Rear half
B
B
Front half
Rear half
Suggested pickup arrangement
Fitting hornblocks
Brake overlay and pull rod
B
Plain inner rod
Outer rod. Note
half-etch to
outside
SKETCH 2
Showing T-shaped piece fixed
to underside of body at rear.
