B. Introduction to 2.4GHz Wireless A/V Link
This sender system is a wireless audio/video sender that uses
advanced wireless communication technology to deliver consistently
sharp audio and video up to 100 meters away. By transmitting at a
very high frequency (2.4 GHz), it avoids the crowded 900 MHz band
used by many cordless telephones and other wireless audio/video
transmitters. It’s superior quality is due to wide-band FM rather than
AM signal modulation.
It also integrates an UHF remote control extender to allow you to
control the audio or video source from another room using your
existing remote controller.
Using sender system, you can enjoy greater convenience and security
in many ways:
General Application
•
Watch the movie you rent on any TV in house without moving your
VCR, laser disc player or running messy cables.
•
Watch cable or satellite programs on any TV in house.
•
Listen to stereo-quality music from your receiver on any powered
speakers inside or outside the house.
•
Uses multi-receivers for broadcasting to numerous TV sets in other
rooms.
•
Show computer images on a remote TV.
(Additional equipment
required)
Safety & Security Application:
•
Applies as a wireless security system.
•
Monitor your sleeping baby, playing children, the elderly, or the
disabled on TV using your existing camcorder.
•
See who is outside the door on TV through your camera or
miniature CCD camera.
•
Monitors and records meeting from another room.
•
And many more uses!
■
The Using Attention
The outlet of the power supply must have the same voltage as the
local area.
1. Be sure the transmitter and the receiver were connected to the
equipment correctly (e.g. Connect the transmitter to the VCR, and the
receiver to the TV).
2. When DC plug is pull out from transmitter or receiver, it needs to
wait for a few seconds in order to insert it again.
3. When two equipment or more is used at the same time, used
different channels. But a transmitter can be used with several
receivers at the same time.
4. When the equipment is operating, please do not use a microwave
oven near by.
5. The remote controller should face to the receiver IR remote control
window, and the transmitter IR extender should face to the source
A/V equipment. The IR remote has to be within the standard distance.
C. Product Layout
The following illustrations show the names of each component,
button and switch connectors on the transmitter and receiver.
FRONT VIEW of TRANSMITTER and RECEIVER
LED of power
Power switch
2.4GHz antenna
Channel switch
