4
- If the detector runs disorderly, cut the power off and rerun again. If still in error, please contact the installer.
Test:
To test the detector, you can give some gas around in distance of 5cm to the gas convection windows by using
an ignition lighter. Gas testing frequently may result in reducing the sensitivity of the detector. The alarm
density of gas is set according with the criteria of GB15322-2003. The detector will stop alarm and resume
the detecting state while the gas density reduced.
Led information:
RED LED FLASH
Gas leak
GREEN LED FLASH
Warm-up
GREEN LED ON
Work normally
YELLOW LED ON
Inside error
Maintenance:
The user must brush and clean the gas convection windows with a little of cleanser every three months, avoid
the cleanser into the detector in the cleaning process and must retest the detector after cleaning.
Notice:
•
The detector must be installed and connected correctly. It can not work if the power supply is missed
•
Please periodically maintenance according to the directions
•
Test the detector every half a year
•
For various reasons, including, but not limited to, changes in environmental conditions, electric or
electronic disruptions and tampering, the product may not perform as expected. The user is advised to
take all necessary precautions for his/her safety and the protection of his/her property.
Emergency treatment:
•
Shut down the tube valve right away
•
Open the window and make the air flow rapidly
•
Extinguish all fire sources and do not use anything can make fire (e.g.: lighters, matches, etc.)
•
Avoiding open/close all kinds of electricity
•
Check the reason of gas leaking and notice the relative departments and professional persons in time
Via Don Arrigoni, 5 24020 Rovetta S. Lorenzo (Bergamo)
http://www.comelitgroup.com
e-mail:
