Comelit 20003150, Системное руководство

Страница: 31 / 54

31
2 .14 - ART . 20004100 – SONDA DI TEMPERATURA ART . 20046851 – SIMPLEHOME MODULE - 1 DIMMER OUTPUT 300W
Dimmer module Art. 20046851 controls the brightness of loads up to 300W, by means of a bus. The module is
equipped with a digital input that can be used only for connecting a button for controlling the local dimmer (switch
on/off and hold the button down to adjust the brightness).
Using other inputs connected to the BUS, for example modules Art. 20046501, the dimmer module output can be
managed differently. The inputs can be programmed with the following functions:
• Select a pre-set brightness level: when you press the button connected to this input, the brightness is
automatically set to the value indicated by the programming software.
• Adjust the brightness using two buttons: this function involves the use of two inputs - one is programmed
to switch the light off or to reduce its brightness if held down, and
the other is programmed to switch the light on or to increase its
brightness if held down.
• Local dimmer control: in the same way as for the digital input on the dimmer, you can also programme the
input of another module so that a single press switches the light on/off, and holding the
button down adjusts the brightness.
The dimmer can also be set with the Presence detection function. This uses a motion sensor connected to the
input of a digital module to increase the brightness of the light if the sensor detects the presence of a person in
the room, and to reduce the brightness or switch the light off if there is no-one in the room.
• 230VAC halogen lamps: 35 - 300W
• 12V halogen lamps with electronic transformer: 35 - 300W
• Dimmable compact fluorescent lamps (CFL): 10 - 300W
• Dimmable 230VAC LED lamps: 10 - 200W
CONTROLLED LOAD TYPE
For each module, connect only lamps of the same type
TECHNICAL CHARACTERISTICS
Power supply voltage 24VDC ± 5% *
Consumption 15 to 25 mA
Inputs 1 digital input can be used only for connecting a button for controlling the local dimmer, and
not for the presence detection sensor
Indications 1 LED (yellow) for indicating bus status:
when flashing, indicates data transmission via bus, when lit steadily indicates lack of power
supply negative or incorrect device connection.
Positioning On a DIN rail on a dedicated control panel or in junction boxes **
Approvals CE
Operating temperature 0° to 40°C INDOOR USE
Storage temperature -10° to +70°C
Relative air humidity 5 to 95% with no condensation
Weight 70g
Dimensions 35x90x58 mm (2 DIN modules)
* Use Comelit power supply unit ART. 20022101 or other limited power source
** With access allowed only for support or servicing by qualified personnel