ProCenter CTR101-1
Manual Supplement
MS-CTR101-1
Page 2 of 2
Issue Date: June 2003
MicroBlaster Abrasive Hose and Vent Hose Connections
ESD Control ProCenters are equipped with ESD Control handpieces, which are installed in the ProCenter.
MicroBlasters prepared for use with the ESD Control ProCenter are shipped without the standard handpieces
and have their abrasive and vent hoses cut to proper length for installation. Refer to the following drawings
for correct hose connections.
Note: When routing abrasive or vent hoses, avoid sharp bends to prevent excessive hose wear.
If you are connecting a MicroBlaster that has the standard handpiece(s) installed, remove the handpiece(s)
and trim the hose lengths to form a 4-5” diameter loop exiting the fittings on the back of the blaster. Allow a
smooth path to the connection points on the ProCenter.
Single Tank
MicroBlaster
Dual Tank
MicroBlaster
