9
www.combisteel.com
Cleaning and Maintenance of your Ice Maker
Safety rules required to be observed before cleaning your Ice Maker.
1.
Cut off the power before cleaning the Ice Maker, unless otherwise specified in the cleaning instructions.
2.
Never wash the outer casing of the product. This causes undesired electrical failures and jeopardizes the
safety of the user.
3.
Always wear protective gloves and similar protective clothes before beginning cleaning.
4.
Do not use cleaning agents and chemical substances which may cause cutting, piercing and corrosion during
cleaning. Otherwise, your ice maker will be out of warranty.
5.
No cleaning agents not recommended by the Frozy brand should be used.
Outer Cleaning of the Ice Maker
The outer casing of the product is made by stainless steel. For this reason, wipe it with a cotton and
damp cloth or a sponge. Thereafter, dry it with a dry and cotton cloth.
Cleaning of the Ice Tank
Remove all the ices inside the ice reservoir. Wipe the inside surface of the reservoir with a soapy cloth.
Re-wipe with a clean wet cloth. Thereafter, dry with a dry cloth.
Take care not to allow any lime and cleaning solution residue to remain.
Cleaning of the Sprayer System
Make the water and electrical connection of the product in compliance with the instructions.
The power switch should be closed, and the water inlet valve should be opened.
Remove the wire located inside the pool and then remove the level discharge plastic from its slot, and ensure
the water to be discharged.
(See Figure 3)
Place the level discharge plastic back to its slot after discharging the water inside the pool.
(See Figure 4)
Set your product to the cleaning position.
(See Figure 5)
Then, pour the cleaning solution recommended by Frozy Authorize Service into the water pool.
Set the power button to the “Open” position.
The cleaning process will continue for 3 hours and 20 minutes.
Do not stop the product while cleaning is in process.
Thereafter, discharge the water inside the water pool. (See Figure 3)
Right after this cleaning, the Ice Set must be cleaned.
Cleaning of the Ice Set
Remove the top cover (See figure 6) and clean the cooling pipes and the visible surfaces on the reservoir with a
soapy cloth. Dry thereafter. Close the top cover of the product.
Cleaning of the Water Inlet Filter
Cut off the power of your ice maker. Cut off the water connection of your ice maker.
Remove the water inlet filter and maintain it. (Even though the cartridge replacement frequency depends on the
usage period, it is recommended to be replaced every 6 months.)
Apply the assembly instructions of the Ice Maker and make it functional.
Application contained in the cleaning instructions of the product should be performed at least 4-5 times in
year.
Содержание 7489.4 Series
Страница 3: ...3 www combisteel com...
Страница 4: ...4 www combisteel com...
