4
www.combisteel.com
IMPORTANT SAFETY PRECAUTIONS
WARNING
To reduce the risk of fire, electrical shock, or injury
when using your appliance, follow these basic
precautions:
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Read all instructions before using the wine or beverage cooler.
DANGER or WARNING: Risk of child entrapment.
To avoid the possibility of child entrapment, please take the following precautions before throwing out
the appliance.
-
Remove all doors from the unit.
-
Leave the shelves in place so that children may not easily climb inside.
Never allow children to operate, play with, or crawl inside the appliance.
Refrigerants: All refrigeration products contain refrigerants, which under the guidelines of federal law
must be removed before disposal of product. It is the consumer’s responsibility to comply with federal
and local regulations when disposing of this product.
Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or explosion.
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other
appliance. The fumes can create a fire hazard or an explosion.
-Save these instructions-
INSTALLATION INSTRUCTIONS
Before Using Your Appliance
Remove the exterior and interior packing.
Before connecting the appliance to the power source, let it stand upright for approximately 4 hours. This will
reduce the possibility of a malfunction in the cooling system from improper handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Free-Standing Installation
This appliance is designed to be installed built-in or free standing.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Ambient
temperature below 68°F (20°C) or above 90°F (32°C) will hinder the performance of this appliance. This unit
is not designed for use in a garage or any other outside installation.
Avoid locating the appliance in moist areas.
Plug the appliance into dedicated, properly installed-grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized service center. This unit is not
designed to be installed in an RV or used with an inverter.
After plugging the appliance into a wall outlet, allow the unit to cool down for 3 ~ 4 hours before placing
wine bottles or beverage cans in the appliance.
Built-In Installation
The cutout dimension illustrated in figure (A) allows for door swing and access to the pull-out shelves when
installed as a built-in appliance. If installing between frameless cabinets, a ½” wide filler strip or side panel may
be needed on hinge side. The filler strip will act as a spacer between the appliance case and adjacent cabinet
door swing. The width of the opening must include the filter panels.
