CombiSteel 7455.1105, Руководство пользователя

Страница: 5 / 18

5
www.combisteel.com
Installation and safety rules

It might cause vibration or noise due to unstable location. Please place the refrigerator on an even and
hard floor.

Place the refrigerator in a dry, regularly ventilated room, in order to increase refrigerator efficiency and
reduce energy consumption. Therefore, ample space should be kept around the refrigerator. The rear
wall of the appliance should be at least 100mm from the wall. The two sides should be at least 200mm
away from the wall. The tabletop should be at least 300mm away from the ceiling.

The refrigerator should be away from hot sources and direct sunshine.

The appliance should be placed on a solid base and away from heavy moisture. If the appliance is located
in a wet place, it might affect electricity insulation and become rusty. If electrical parts are splashed
with water, it might cause electricity leakage or breakdown.

Power supply:
The appliance is fit for the single-phase alternating power supply with the voltage of 187V
～
242V, and
the frequency of (50±1)HZ.

Plug:
It is better to use an individual socket. It is dangerous to use multiple sockets. The plug must be plugged
into an appropriately grounded wall socket.

Avoid water splashing. If electrical parts are splashed with water, it might cause electricity leakage or
breakdown.

Be sure not to put flammable objects into the refrigerator. Such as gasoline, propane, adhesive, and so
on.

Never turn it over when you want to move the refrigerator. The obliquity of the refrigerator should be
over 45°.
First operation

The temperature is nearly the same as the ambient temperature when the appliance operates for the
first time. Generally, it takes 2 hours to enable the temperature inside to reach minus one, which can
stop the motor running automatically.

After working for 2 hours with reference to the following instructions, adjust the temperature control
to a suitable position and close the door, so the appliance can work normally. (Thermostat controls
compressor to stop and start automatically.) Now, you can store food in it.
(NOTE: This table is for the reference of adjusting the temperature of the refrigerator when it is operated
for the first time only.)
MODEL OPERATING REQUIREMENT INDICATION POSITION OF THE KNOB
LG4-336 / 7455.1200
LG4-600 / 7455.1205
LG4-800 / 7455.1215
For the first start STRONG (BEYONd “6”)
After 3 hours “3”
When it is necessary to lower the
temperature again
“4
～
6”
If you think the temperature is too low “1
～
2”

Be sure not to store any food in it before it starts to work normally.