Combi Tyro 8000 Series, Инструкция по эксплуатации

Страница: 21 / 36

Check for secure installation. Pull front to back and left to right to check for secure
installation
(fig. c) . Vehicle lap belt MUST stay tight.
If vehicle lap belt does not stay tight, see “Installation with Lap/Shoulder Belts” below.
Recheck car seat recline. Verify line is in green striped zone of recline indicator.
Installation with Lap/Shoulder Belts:
• When using vehicle lap/shoulder belts, shoulder belt may be used for additional support.
Place shoulder belt around back of Tyro
™
(fig. d) and through the vehicle shoulder belt
guide on back of car seat shell (fig. e) . If shoulder belt is too short to go around back of
Tyro
™
, position shoulder belt through the lap belt guide above the vehicle buckle and
against vehicle seat back (fig. f) . Do not route shoulder belt through lap belt guides on
both sides of car seat.
• Lap/shoulder belt with free sliding latch plate:
- Pull out on latch plate (fig. g) . If belt slides freely through latch
plate, a belt lock-off must be used as described in “Belt Lock-off”
section.
- Some combination lap/shoulder belts with free sliding latch plates
may be converted into an “automatic locking mode” that will allow
use without a belt lock-off. See vehicle owner’s manual and label
on vehicle belts for instructions.
Removal Of Infant Car Seat From Vehicle:
Unhook shoulder belt from behind car seat and unbuckle vehicle
seat belt.
Remove lap belt from vehicle lap belt guides.
Push in handle buttons on each side of handle and rotate to
upright carry use position (see “Carry Handle Operation” section).
Remove car seat from vehicle.
20
(fig. e)
(fig. c)
(fig. d)
Shoulder
Belt Guide
8
9
1
2
3
4
Shoulder
Belt
(fig. g) (fig. f)
Latch
Plate
TICS1203e (EN).qxd 4/4/05 4:15 PM Page 21