© 2015 Comba Telecom. All rights reserved
Information contained in this document is subject to confirmation at time of ordering.
Specifications may differ depending on region and customers’ requirements.
DS-Control: 1-0-0 / 0118
INSTALLATION INSTRUCTION
Step 1
：
Assemble the bracket
Step 2
：
Install the bracket
As shown, put the mounting bracket onto the
mounting pole and tighten the two M10.
Mounting pole
Φ5
0-
Φ
80mm(not supply)
Step 3
：
Install the Antenna
Remove the four screws from the antenna back
panel, and install the antenna onto the bracket
through the four screws.
Information contained in this document is subject to confirmation at time of ordering.
on and customers’ requirements.
INSTALLATION INSTRUCTION
bracket onto the
mounting pole and tighten the two M10.
80mm(not supply)
Remove the four screws from the antenna back
panel, and install the antenna onto the bracket
Step 4
：
Adjust the mechanical downtilt angle
The antenna can be turned horizontally and vertically,
both adjustment range is ±45°,then tighten all the
screws. (please use the inclinometer for the
precise angle)
*Only qualified personnel are allowed to install the
antenna.
Nuts
Torque
M8
M10
Page 2
Adjust the mechanical downtilt angle
The antenna can be turned horizontally and vertically,
adjustment range is ±45°,then tighten all the
screws. (please use the inclinometer for the
Only qualified personnel are allowed to install the
Torque
20 Nm
44 Nm
