NMEA-2-WIFI
4
3 OPERATION
On applying power the Green ON LED will light and the Green STATUS LED will
flash slowly. If the units NMEA Inputs are connected to other equipment which are
sending data then the Red DATA LED will flash, the frequency dependent on the
amount of data being transferred.
3.1
WIFI Connection
The NMEA-2-WIFI unit creates a Wireless Access Point which enables another
device to connect to it and share data.
To set up a WIFI connection is a two stage operation, firstly the WIFI device such as
a smart phone or PC must be on the same network, and secondly it needs to be
connected to the program that you are using.
With the unit powered on and connected to your NMEA equipment, scan for
wireless networks on the device you wish to connect to. This procedure will vary
between devices so consult the user manual of the device you are using.
The device will show a list of WIFI networks in range. On the list you will see a
network with the name “NMEA-2-WIFI xxx” where xxx is a 3 digit number unique to
your device. Connect to this network as per your devices instructions.
Once connected you need to run the application that accepts NMEA data over
TCP/IP, configure the application to listen on:
IP Address 1.2.3.4 Port 2000
The Green STATUS LED should be on constantly to confirm a connection has been
made.
Содержание NMEA-2-WIFI
Страница 2: ......
